General Maintenance; Cleaning And Replacement - Jilong 29P414US User Manual

suitable for the filter pump. Contact a qualified electrician if you cannot
verify.
Insert the plug into the power receptacle. (1)
Press the "RESET" button. The indicator light should turn red. (2)
Then press the "TEST" button. The indicator light should disappear. (3)
WARNING: Do not use if above test fails.
Finally, press the "RESET" button again. The indicator light should turn
red. The filter pump is ready for use. (4)

General Maintenance

To avoid dangerous or fatal electrical shock hazard, always disconnect
power to the unit before attempting to clean pump.
There is no need for any regular mechanical maintenance of the pump
unit. (Do not attempt to disassemble the pump motor at any time).
If necessary, clean outside of pump with a mild detergent and water,
rinsing off with a hose.
There is no need for the use of any lubricants on the pump.
Do not use solvents clean the filter cartridge, as they will cause
damage to the plastic components inside the pump.

Cleaning and Replacement

The filter cartridge in your pump filter system should be replaced
approximately once per month.
Periodically cleaning of your filter cartridge can enhance the
effectiveness of your filter pump and moderately prolong the cartridge's
lifespan prior to replacement.
Keep the power be disconnecting to the unit when cleaning the filter
cartridge.
Remove the Strainers(P14)inside of the pool, and close the caps of the
pools Wall Plugs(P13).
Turn the Air Vale Screw to release the air suction inside.
Remove the Filter Chamber Cover and the filter chamber rubber
gasket, and then take out the filter cartridge.
8
www.jilong.com FP4-14-GB(V4)