Honeywell CL201AE User Manual page 3

USE & OPERATION (CONTINUED)
FUNCTION BUTTONS (CONTINUED)
SPEED
Press the SPEED button repeatedly to change the speed between HIGH - MED - LOW.
The indicator light will show the selected speed:
High (HIGH)
TIMER
Press the TIMER button until the desired time duration setting is selected. When the set time has
passed, the unit will automatically turn off (unit remains in Standby mode until power cord is unplugged
from electrical socket). The TIMER function allows you to program the unit for up to 8 hours of use.
SWING
Press the SWING button until the SWING indicator light is illuminated on the
control panel. The louvers will begin to move left to right automatically.
Vertical Air Flow - You can manually adjust the louvers to change vertical air flow.
COOL
Press the COOL button until the COOL indicator light is illuminated on the control panel. This activates
evaporative cooling. The water pump will operate and you will feel the cooler air after the Honeycomb
Cooling Media is completely wet. When the COOL indicator light is switched OFF, the unit can still
function in a fan only mode (without evaporative cooling).
ROOM COOLING AND HUMIDIFYING
In cooling mode, Honeywell Air Coolers provide cool, moist air through the
evaporation of water. There is a manual Water Regulator knob located in
the ice compartment of the unit. This allows you to adjust the amount of
water pumped over the Honeycomb Cooling Media, thus helping to control
cooling and humidification levels.
When the Water Regulator is set to MIN, the water pump distributes a
minimal amount of water to the Honeycomb Cooling Media. This results in
less water evaporation and reduces the cooling effect.
When the Water Regulator is set to MAX, the water pump distributes the maximum amount of water to
the Honeycomb Cooling Media. This results in maximum water evaporation and greater cooling
performance.
REMOTE CONTROL
ON/OFF
MODE SWING
TIMER
COOL
SPEED
Note:
• The remote control requires AAA (2 x 1.5V) batteries for replacement.
• Open the battery compartment at the back of the remote control and insert the batteries inside. Care
must be taken to insert the batteries according to the correct polarity (+ / –) markings shown inside
the battery compartment.
Medium (MED)
POWER : ON / OFF
SPEED : Low / Medium / High
COOL : Controls cooling or fan option
SWING : Controls the motion of the louvers
TIMER : Controls the Timer function for automatic off
MODE : Switch between Normal, Natural & Sleep
EN 2
Low (LOW)
LOUVER
MOVEMENT
Water Regulator
MAX
MIN