Haivision Mantaray Quick Start Manual page 2

5. Connect the video and audio output jacks to the monitor, using the appropriate connector(s):
Connect
power cable
here
Composite Video Out
(CVBS, 1 RCA jack)
• HDMI Digital Video+Audio: Use an HDMI cable to connect the HDMI jack.
• VGA Analog Video+Baseband Audio: Use a VGA cable to connect the VGA jack.
• Composite (CVBS) NTSC/PAL Analog Video+Baseband Audio: Use a composite A/V cable to connect the
Composite video (yellow RCA jack).
• Y,Pb,Pr Component Video+Baseband Audio: Use a component cable to connect the Component
(Y,Pb,Pr) jacks.
For Baseband audio, use an A/V cable to connect the audio (red/white RCA jacks) jacks.
NOTE Only one A/V source is active at a time.
6. Install the two AAA batteries in the remote control.
7. Connect the power cable to the Mantaray, and then plug the power adapter into a wall socket. Use only the
A/C power adapter provided with the unit.
Mantaray automatically starts when you connect the power cord to the STB.
TIP For HDMI output, be sure to connect the HDMI cable and turn on the monitor before connecting
the power supply to Mantaray.
Otherwise, Mantaray will use an incorrect resolution and the display will appear distorted. If this occurs,
you can use the following workaround: Press the Video button on the remote control to change the
Mantaray's output resolution, and the played video will become normal. If the Video button is locked,
see the TIP on page 3 to unlock the Video button.
HVS-ID-QS-MANTA-103, Issue 01
Component Video Out
(YPbPr, 3 RCA jacks)
2-Channel
Audio Out
(2 RCA jacks)
S/PDIF Audio Out
(RCA/coaxial)
VGA Out
HDMI Out
S/PDIF Audio Out
(TOSLINK optical)
Mantaray Quick Start Guide
Physical Installation
Page 2 of 8