Default Gateway; Dns Nameservers - Cisco C3124SA Manual

Chapter 3 Array Configuration
Table 3-1
MODE NAME
mode=4
(802.3ad)
Link Aggregation
Control Protocol
(LACP)
mode=6
(balance-alb) [Default
setting on Cisco
Arrays]

Default Gateway

The default gateway is the device that connects the local network to another network.
To update the default gateway, do the following:
Choose Array Configuration > Network Settings.
Step 1
The Network Setting window appears.
Click Default Gateway.
Step 2
The Update Default Gateway dialog box appears.
Enter the Gateway IP address.
Step 3
A check mark appears if it is a valid gateway.
Click Save Gateway or click Cancel to return to the Network Settings window.
Step 4

DNS Nameservers

The most important function of the Domain Name Server DNS servers is the translation (resolution) of
human-memorable domain names and hostnames into the corresponding numeric Internet Protocol (IP)
addresses.
To edit the Nameservers, do the following:
Choose Array Configuration > Network Settings.
Step 1
The Network Setting window appears.
OL-31370-01
Bonding Modes (continued)
DESCRIPTION
IEEE 802.3ad Dynamic
link aggregation creates
aggregation groups that
share the same speed and
duplex settings. This
utilizes all slaves in the
active aggregator
according to the 802.3ad
specification. Most
switches require some
type of configuration to
enable 802.3ad mode.
Adaptive load balancing:
includes balance-tlb plus
receive load balancing
(rlb) for IPV4 traffic and
does not require any
special switch support.
Cisco UCS Invicta C3124SA Appliance Administration and Configuration Guide
ADDITIONAL INFORMATION
Pre-requisites:
ethtool support in the base drivers for
•
retrieving the speed and duplex of each slave.
A switch that supports IEEE 802.3ad
•
Dynamic link aggregation.
ALB (mode 6) is the default mode.
3-3