Maintenance; Twist And Edge Button - McCulloch Li 58T Operator's Manual

To edge the grass
1. Make sure that the grass trimmer line is vertical to
the ground when you edge. Walk slowly along the
area to be cut.
2. Do not push the trimmer head to the ground. The
ground and the product can be damaged.
3. Do not let the trimmer head touch the ground
continuously because it can cause damage to the
trimmer head.
WARNING: Read and understand the safety
chapter before you clean, repair or do
maintenance on the product.
Daily maintenance
• Remove the battery pack. Refer to the operating
instructions of the battery pack for correct

maintenance.

• Examine the nuts, screws and bolts.
• Examine the trigger for correct operation.
• Examine the power button for correct operation.
• Remove external unwanted material from the
product with a soft brush or dry cloth. Do not clean
with water, cleaning fluids, or solvents.
• Use a soft brush to remove unwanted material from
the air vents.
• Examine the product for missing, damaged, loose or
worn parts.
• Examine the product to make sure the moving parts
align and are safe for operation.
• If the product is damaged, speak to an approved
service center. Do not use a damaged product.
10
4. Use full throttle.
5. Make sure that the trimmer line ejects the cut
material into an area that was cut before.
To use the twist and edge button
The twist and edge button of the product lets the
operator turn the trimmer head. This makes it easier to
edge along walks or driveways.
1. Push and hold the button while you turn the motor
housing 180 degrees.
2. Release the button to lock the motor housing in edge
mode
MAINTENANCE
To replace the trimmer line
1.
2.
CAUTION: Always stop the product and
make sure the trimmer head does not move
before you change the mode of cut.
455 - 002 - 20.11.2017