Remington REM-B200LT-F User's Manual And Operating Instructions page 14

POSITIONING THE HEATER
This heater can be mounted on a wall or on a floor by using the
Support Legs included with select models. For convenience
and efficiency, install the heater as follows:
• In a location with easy access for operation, inspection, and service.
• In the coldest part of the room.
• A minimum of 3' (36") away from furniture and draperies.
FLOOR MOUNTING (SELECT MODELS)
NOTE: This is an optional accessory and is not required for
operation of the heater. Floor mounting cannot be done in a
bedroom or bathroom and cannot be used for garage and ice-
house heaters.
Before installing the Support Legs to the heater base, ensure
you have the following items:
• (2) Support Legs
• (4) Support Leg Screws
1. To prevent scratching, place a blanket onto the table where
the heater will be placed for leg installation.
2. Place the back of the heater on the table with the bottom of
the heater extending past the table edge.
3. Fasten the Support Legs to the heater using the Support Leg
Screws (Fig. 9)
NOTE: If installing the heater directly on carpeting, tile, or other
combustible material, other than wood flooring, the heater must
be installed on a metal or wood panel extending the heater's full
width and depth.
4. Once the heater is in place, secure it to the floor using the
Support Leg Screws and mounting holes found on the
heater Support Legs (See Fig. 10).
©2017 Pinnacle Climate Technologies
Installation (cont.)
14
Fig. 9—Attaching the Legs
Fig. 10—Securing the Legs
Vent-Free Gas Heater User's Manual