Table of Contents
Advertisement
1. Handle the decal sheet carefully to avoid damage. Do not crease the decal sheet.
2. Use a pair of sharp scissors or a hobby knife to cut out the decals.
3. Cutting out decals that will be positioned close together on the rocket as one block
will make them easier to apply.
4. Make smooth cuts. Small knicks can cause a decal to tear when it is being peeled
off the backing sheet.
5. Before starting to peel decals off their backings, fill a soup bowl with warm water
and put one or two drops of a dishwashing detergent into the water.
6. Carefully peel a decal off its backing, dip it into the detergent solution and apply
the decal to the rocket. The detergent solution prevents the adhesive on the decal
from "grabbing" the rocket surface too quickly and allows accurate positioning of
the decal.
7. Gently press any air bubbles out from under the decal and then dab the decal dry.
8. Apply the rest of the decals in the same manner.
DECAL INSTRUCTIONS
8
Advertisement
Table of Contents
