Maintenance - Scandomestic WAH 140 User Manual

you will hear a beep, then the buzzer will be closed. To restore
the buzzer function, press the "Temp."button again for 3 seconds.
The setting will be kept until the next reset.
Warning: After deactivating the buzzer function, the sounds will
not be activated any more before you reset it.
Washing Procedures
The energy class is A+
Energy test program: Cotton intensive 60 °C/40 °C;
Half load for 5.0kg/6.0Kg machine: 2.5kg/3.0Kg.
"Cotton 60 °C/40 °C+intensive" are the "standard 60 °C/40 °C
cotton program and are the standard washing programs to which
the information in the label and the fiche relates, and these
programs are suitable to clean normally soiled cotton laundry
and that they are the most efficient programmes in terms of
combined energy and water consumptions for washing that type
of cotton laundry, that the actual water temperature may differ
from the declared cycle temperature;
Please choose suitable type of detergent for the various washing
temperature to get the best washing effect with less water and
energy consumption.
Notes:
The parameters in this table are only for user's reference. It is
difference from the normal time when using depend on the tem-
perature and the load .

Maintenance

Before your maintenance starts, please do pull out the pow-
er plug or disconnect power and close the tap.
- Solvents are forbidden to avoid that the washing machine is
damaged, and toxic gases are generated or exploded.
- Never use water to sprinkle and wash the washing machine.
- It is forbidden that the detergents containing PCMX are used
to clean the washing machine.
Table of Washing Procedures
Program/description Weight (kg)
6,0
Quick 2,0
Cotton intensive 6,0
Spin 6,0
Drum Clean 0
Cotton 6,0
Synthetic 3,0
Wool 2,0
Underwear 6,0
Cleaning and Maintenance of Washing Machine Cabinet
Proper maintenance on the washing machine can extend its
working life. The surface can be cleaned with diluted non-abra-
sive neutral detergents when necessary. If there is any water
overflow, use the wet cloth to wipe it off immediately. No sharp
items are allowed to strike the cabinet.
Notes: formic acid and its diluted solvents or equivalent are for-
bidden.
Clean Internal Drum
The rusts left inside the drum by the metal articles shall be remo-
ved immediately with chlorine-free detergents.
Never use steel wool.
Dispose a Frozen Washing Machine
When the temperature drops below zero and your washing ma-
chine gets frozen, you may:
1 Disconnect the power supply for the washing machine.
2 Wash the tap with warm water to loosen inlet pipe.
3 Take down inlet pipe and immerse it in warm water.
4 Pour warm water into washing drum and wait for 10 mi-
5 Reconnect inlet pipe to the tap and check whether inlet and
Anti-freeze
If your washing machine is located in the room where it can get
frozen easily, please drain the remaining water inside drain pipe
and inlet pipe thoroughly. Remove the remaining water in inlet
pipe:
1 Close the tap.
2 Screw off the inlet pipe from tap and put its end into the
3 Start up any procedure except single Wash or Drain proce-
4 Reconnect the inlet pipe to tap.
Detergent box
Box 1 Box 2 Softener case
Must Optional
Must Optional
No No
No No
Must Optional
Must Optional
Must Optional
Must Optional
21
nutes.
outlet are working normally.
Notes: when the washing machine is reused, make sure the
ambient temperature is above 0 °C
container.
dure. Water will be drained out of inlet pipe if any for about
40 seconds.
Default temp. Default time (min)
Cold 14
60 210
NA 12
90 73
40 90
40 84
40 76
40 98
Speed
800
1200
1000
400
1000
800
400
1000