Weil-McLain Aqua Balance WMB-155 Manual page 111

W
TM
AquaBalance
35 Maintenance
Figure 148
Heat exchanger components
Heat Exchanger
Ignitor
Spring
Heat exchanger cover
plate and gasket
Part number 550-100-305/0118
M -
ALL OUNT GAS FIRED WATER BOILER
(continued)
Refractory
Burner and
burner gasket
—
Boiler Manual
Procedure For Cleaning Heat Exchanger
Waterways
This procedure is intended as a guideline for a correct restoration
of the functionality of the boiler as a result of operation with
untreated water, very hard water feeding conditions, debris, lime
scale, sludge, metal oxides and, in low temperature systems, also
biomass in the heat exchanger water circuit.
• Carefully read and follow the instructions below.
• Cleaning and maintenance must be carried out by profes-
sionally qualified personnel, in compliance with the current
regulations and according to the manufacturer's instructions.
Do not carry out any operation on the sealed control parts.
• Before carrying out any cleaning or maintenance operation,
disconnect the unit from the electrical power supply using
the switch and/or the special cut-off devices.
• The disposal of chemicals and residues of cleaning should
be carried out in an appropriate manner, in accordance with
current standards.
• Before installation of the boiler, carefully flush all the pipes of
the system to remove residues or impurities that could affect
the proper operation of the unit. Use chemical conditioners
and cleaners listed on Pages 72 and 117.
• If it is necessary a cleaning of the heat exchanger circuit to
recovery the functionality of the boiler as a result of opera-
tion with untreated water, very hard water feeding condi-
tions, sludge, metal oxides and, in low temperature systems,
also biomass in the heat exchanger water circuit, is allowed
the use of chemical products for the cleaning, if and only if
the manufacturer of these fluids provides a guarantee which
ensures that its products are suitable for use and cause no
damage to the heat exchanger or other components and /
or materials of the boiler and system.
Figure 149 Heat exchanger components (Combi-80/120
shown)
2
3
1
1 System supply
2 Domestic hot water outlet
3 Gas inlet
4 Domestic cold water inlet
4
5
6
5 System return
6 Plastic screw, Combi
pressure relief
111