BENQ-SIEMENS Comfort HHB-160 User Manual page 7

6 Headset Bluetooth
Display when charging is in
progress
The LED lights continuously dur-
ing the charging process. When
the battery is fully charged, the
LED goes out.
The battery should only be charged in
an ambient temperature of 0°C to
45°C, otherwise it will wear out pre-
maturely. Please remember that bat-
teries are subject to wear.
Switching the headset on
and off
• Switch on:
a
Press for about
2 seconds. The LED
flashes at short inter-
vals for 1 second, then
at long intervals. A
low and a high tone
can be heard.
If no connectable mo-
bile phone can be
found, please repeat
the pairing.
• Switch off:
a
Press for about
3 seconds. The LED
lights continuously
for 1 second and then
goes out. A high and a
low tone can be
heard.
® Comfort (en)
Establishing the first
connection with the mobile
phone (pairing)
The headset must be switched
off.
1. Press the
least 3 seconds. The LED
lights continuously, and two
high tones can be heard. Your
mobile phone can now "look
for" the headset.
2. Activate the search mode of
your mobile phone. Please
read the notes on this in the
user guide of your mobile
phone.
3. If your mobile phone finds
your headset, this is shown on
the mobile phone display
beneath the device name
HHB-160.
If your mobile phone does not find the
headset within 3 minutes, activate the
search mode again (repeat step 1).
4. If requested, enter the code
(PIN) of the headset on the
mobile phone:
0000
The headset is now registered to
your mobile phone.
For additional information
please consult your mobile
phone's user guide.
a
button for at