Table of Contents
Advertisement
You can store the channel on the current channel number or as
a new channel number. Select Store current channel or Store as
You can redo these steps until you found all available analogue
In some countries, digital broadcasts do not send UTC -
Coordinated Universal Time information. The daylight saving
change might be ignored and the TV might show an incorrect
To correct the TV clock, press h > Setup > TV settings >
Preferences > Clock and select Country dependent. Select
.Daylight saving and select the appropriate setting
To set the time and date manually, select Manual. Then select
Setup / Channels
Store 4
.new channel
.TV channels
Clock settings
.time
.Time or Date
If you want to change the DVB setting to start a new channel
installation, press h > Setup > Channel settings and press OK.
Select Channel installation > Antenna or Cable DVB and press
.OK. Select the DVB setting you want
For ease of use, all DVB-C settings are set to automatic. If your
DVB-C provider gave you specific DVB-C values, like a symbol
rate or a frequency, enter these values when the TV asks for
You can set up your TV for DVB-T and DVB-C. Install one
system followed by the other. When both installations are
complete, the Channel list will show both DVB-T and DVB-C
If you receive digital channels, you can check the quality and
If you use an antenna, you can reposition the antenna to try and
To check the reception quality of a digital channel, switch to the
channel and press h > Setup > Channel settings and press
OK. Select Channel installation > Digital : reception test and
The digital frequency is shown for this channel. If the reception is
poor, you can reposition your antenna. To check the signal
.quality of this frequency again, select Search and press OK
To enter a specific digital frequency yourself, select the frequency,
position the arrows on a number with x and w and change the
number with u and v. To check the frequency, select Search
If you use DVB-C to receive channels, the options Symbol rate
mode and Symbol rate are available. For Symbol rate mode,
select Automatic, unless your cable provider gave you a specific
symbol rate value. To enter the symbol rate value, use the
Manual installation — Analogue
Analogue TV channels can be manually tuned in channel by
To install analogue channels manually, press h > Setup >
Channel settings and press OK. Select Channel installation >
.Analogue : manual installation and press OK
To set up the TV system, select System and press OK. Select
.your country or part of the world where you are now
To find a channel, select Find channel and press OK. Select
Search and press OK. You can also enter a frequency yourself. If
the reception is poor, press Search again. If you want to store
.the channel, select Done and press OK
To fine tune a channel, select Fine tune and press OK. You can
fine tune the channel with u or v. If you want to store the
.channel found, select Done and press OK
DVB-C channel installation
.them during installation
DVB-T + DVB-C
.channels
Reception quality
.signal strength of a channel
.improve the reception
.press OK
.and press OK
.number keys
.channel
System 1
Find channel 2
Fine tune 3
42
Advertisement
Table of Contents
