Extending The Power Cable - Samsung AC***MXSCCC Installation Manual

Extending the power cable

1. Prepare the following tools.
Tools
Spec
Shape
2. As shown in the figure, peel off the shields from the rubber and wire of the
power cable.
- Peel off 0.79 inch(20 mm) of cable shields from the pre-installed tube.
For information about the power cable specifications for indoor and
outdoor units, refer to the installation manual.
CAUTION
After peeling off cable wires from the pre-installed tube, insert a
contraction tube.
3. Insert both sides of core wire of the power cable into the connection sleeve.
Method 1
Push the core wire into the sleeve from both sides.
Method 2
Twist the wire cores together and push it into the sleeve.
4. Using a crimping tool, compress the two points and flip it over and compress another two points in the same location.
- The compression dimension should be 0.31 inch (8.0 mm).
- After compressing it, pull both sides of the wire to make sure it is firmly pressed.
Compression
dimension
Crimping pliers Connection sleeve
20xØ0.26 inch(6.5 mm)
MH-14
Method 1
Compress it 4 times.
0.20 inch
(5 mm)
English-33
Insulation tape
Width 0.75 inch(19 mm)
(HxOD)
Power cable
Pre-installed tube for the power cable
Contraction tube
70xØ0.31 inch(8.0 mm)
(LxOD)
20 20
0.79 (20) 0.79 (20)
0.79 (20)
60
2.36 (60)
120
4.72 (120)
180
7.09 (180)
Unit: inch(mm)
0.79 (20) 20
Connection sleeve
Connection sleeve
Method 2
Compress it 4 times.
0.20 inch
(5 mm)
20