Install The Rear Panel On The Wall; How To Take Out Front Grille; Indoor Unit Installation - Panasonic S-15MK2E5A Installation Instructions Manual

3-4. Install the Rear Panel on the Wall

Be sure to confirm that the wall is strong enough to suspend the
unit.
(1) Make sure the panel is flush against the wall. Any space
between the wall and unit will cause noise and vibration.

3-5. How to take out Front Grille

Please follow the steps below to take out front grille if necessary
such as when servicing.
(1) Set the vertical airflow direction louvers to the horizontal
position.
(2) Remove the 2 caps on the front grille as shown in the
illustration below, and then remove the 2 mounting screws.
(3) Pull the lower section of the front grille towards you to
remove the front grille.
Front grille
When reinstalling the front
grille, first set the vertical airflow
direction louver to the horizontal
position and then carry out above
steps (2) - (3) in the reverse order.

3-6. Indoor Unit Installation

● Do not turn over the unit without its shock absorber during
pull out the piping.
It may cause intake grille damage.
● Use shock absorber during pull out the piping to protect the
intake grille from damage.
Piping
AMP Air Conditioning
Vane
Cap
Vane
(Move the vane
to upward)
Screw
Cap
Intake grille
(1) For the Right Rear Piping
Step 1
↓
Step 2
↓
Step 3
↓
Fig. 3-6
Step 4
Right Rear piping
Fig. 3-7 Tape it
with piping in a
position as mentioned
in Fig. below.
Drain hose
Fig. 3-8
How to keep the cover
In case of the cover is cut, keep the cover at the rear of chassis
as shown in the illustration for future reinstallation.
(Left, right and 2 bottom covers for piping.)
Fig. 3-9
8
www.ampair.co.uk | sales@ampair.co.uk
Piping
Shock absorber
Pull out the Indoor piping
Install the Indoor Unit
Secure the Indoor Unit
Insert the power supply cord and connection
cable
• Insert the cables from bottom of the unit
through the control board hole until terminal
board area.
Piping
Cover for the
Cover for
bottom piping
the right
Cover for
piping
the bottom
piping
Cover for piping
Fig. 3-10
Cover for
the left
piping
Fig. 3-11
Fig. 3-12