Device Settings Gui - Focusrite Red 16Line User Manual

Device settings GUI

Sync Indicator
sync Indicator – Will be illuminated if Red 16Line is locked to a valid clock source.
Channel Gain – Sets the input gain on analogue channels 1 & 2; click-and-drag to change.
Channel Function – Click to select an input function. See page 11 for Function descriptions.
Input type – Click to select the input signal type. Also see page 11 for Type descriptions.
sample Rate – Select from: 44.1kHz, 48kHz, 88.2kHz, 96kHz, 176.4kHz, 192kHz.
Clock source – Internal, S/PDIF, ADAT 1 & 2, Word Clock, Dante, Loop Sync (Pro Tools host mode).
s/pDIF source – RCA, Optical.
Meter source – Internal, S/PDIF, ADAT 1 & 2.
host Mode – Thunderbolt or Pro Tools. Changing Host type will cause the device to perform a power reset.
analogue I/o Line Level setup – Cick to select channel I/O gains globally or by individual channel.
Monitor Controls – Click to select which channels are being controlled by the unit's Output Encoder:
• Monitors:
• Monitors + 3-4:
• Monitors + 3-6:
• All:
Monitor L/R Outputs
Monitor L/R Outputs + Line Outputs 3–4
Monitor L/R Outputs + Line Outputs 3–6
Monitor L/R Outputs + Line Outputs 1–16
Channel Gain
22
Channel Function Input Type