Figure 6. Cut-Out Locations
HOLE
Figure 7. Closet or Alcove Floor Cut-Out
MOUNTING
PLATE
REAR WALL
f
FUEL
1/16TH. LARGER THAN
DUCT CONNECTOR
Figure
8, Mounting
Plate
BEND CONNECTOR TABS
UNDER DUCT OPENING
MOUNTING
PLATE
FLOOR
CUTDUCTOPENING
a.
Place duct connectorthroughthe floor
b.
Figure 9. Duct Connector
opening with bottom tabs resting on
top of the supply air duct.
Center duct connector and push back
against rear edge of floor opening.
c.
Mark cut-out location (tab area) and
remove duct connector.
d.
Cut out duct opening 1/4" larger than
area marked.
9