Hyundai i30 2018 Owner's Manual page 417

Hide thumbs Also See for i30 2018:
Table of Contents

Advertisement

(Continued)
Turn the engine off and wait until
the engine cools down. Use
extreme care when removing the
coolant cap. Wrap a thick towel
around it, and turn it counter-
clockwise slowly to the first
stop. Step back while the pres-
sure is released from the cooling
system. When you are sure all
the pressure has been released,
press down on the cap, using a
thick towel, and continue turning
counterclockwise to remove it.
WARNING
The electric motor for
the cooling fan may
continue to operate
or start up when the
engine is not running
and can cause serious injury.
Keep hands, clothing and tools
away from the rotating fan blades
of the cooling fan.
The electric motor for the cooling fan
is controlled by engine coolant tem-
perature, refrigerant pressure and
vehicle speed. As the engine coolant
temperature decreases, the electric
motor will automatically shut off. This
is a normal condition. If your vehicle
is equipped with GDI, the electric
motor for the cooling fan may begin
to operate at any time and continue
to operate until you disconnect the
negative battery cable.
Recommended engine coolant
• When adding coolant, use only dis-
tilled (deionized) water for your
vehicle and never mix hard water in
the coolant filled at the factory. An
incorrect coolant mixture can result
in serious malfunction or engine
damage.
• The engine in your vehicle has alu-
minum engine parts and must be
protected by an ethylene-glycol
with phosphate based coolant to
prevent corrosion and freezing.
• DO NOT USE alcohol or methanol
coolant or mix them with the spec-
ified coolant.
• Do not use a solution that contains
more than 60% antifreeze or less
than 35% antifreeze, which would
reduce the effectiveness of the solu-
tion.
For mixture percentage, refer to the
following table.
Mixture Percentage
Ambient
(volume)
Temperature
Antifreeze
-15°C (5°F)
35
-25°C (-13°F)
40
-35°C (-31°F)
50
-45°C (-49°F)
60
i
Information
If in doubt about the mix ratio, a 50%
water and 50% antifreeze mix is the
easiest to mix together as it will be the
same quantity of each. It is suitable to
use for most temperature ranges of
-35°C (-31°F) and higher.
Water
65
60
50
40
7
7-23

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents