Cisco 3504 Installation Manual page 37

Installing the Cisco 3504 Wireless Controller
Wizard Setting
Mobility/RF Group
Name
Network Name
(SSID)
Configure DHCP
Bridging Mode
Allow Static IP
Addresses
Configure a RADIUS
Server Now?
Enter Country Code
List
Enable 802.11b
Network
Enable 802.11a
Network
Enable 802.11g
Network
Enable Auto-RF
Configure a NTP
server now?
Action
If desired, enter the name of the mobility group/RF group to which you want the
controller to belong.
Although the name that you enter here is assigned to both the mobility group and
the RF group, these groups are not identical. Both groups define clusters of
controllers, but they have different purposes. All of the controllers in an RF group
are usually also in the same mobility group and vice versa. However, a mobility
group facilitates scalable, system-wide mobility and controller redundancy while an
RF group facilitates scalable, system-wide dynamic RF management.
Enter the network name, or service set identifier (SSID). This is the default SSID
that the access points use when they join a controller.
Enter yes to configure DHCP Bridging Mode. Values are yes or no. The following
message appears:
Warning! The default WLAN security policy requires a RADIUS server.
Please see documentation for more details.
Enter YES to allow clients to assign their own IP address or no to make clients
request an IP address from a DHCP server. Values are YES or no. The default setting
is YES.
If you select YES, you are prompted to enter the following:
• RADIUS Server IP address
• RADIUS server port (default port is 1812)
• RADIUS Server secret
If you select no, the following message appears:
Warning! The default WLAN security policy requires a RADIUS server.
Please see documentation for more details.
Enter the two letter country code. The default country code is the United States (US).
Enter 'help' to see a list of countries.
Choose YES to enable or no to disable the 802.11b radio network. The default is
YES.
Choose YES to enable or no to disable the 802.11a radio network. The default is
YES.
Choose YES to enable
Choose YES to enable or no to disable radio resource management. The default is
YES.
Enter YES to configure an NTP server. The values are YES or no. The default value
is YES.
Using the Startup Wizard
Cisco 3504 Wireless Controller Installation Guide
31