Troubleshooting - Craftsman 944.364780 Owner's Manual

TROUBLESHOOTING - See appropriate section in manual unless directed
to a Sears Parts & Repair Centre.
PROBLEM
Does not start
1. Dirty air filter.
2. Out of fuel.
3. Stale fuel.
4. Water in fuel.
5. Spark plug wire is
6. Bad spark plug.
7. Loose blade or broken
8. Control bar in released
9. Control bar defective.
10. Fuel valve lever (if so
11. Weak battery (if equipped).
12. Disconnected battery
13. Blown fuse (if equipped).
14. Engine control lever is
Loss of power 1. Rear of lawn mower
2. Cutting too much grass.
3. Dirty air filter.
4. Buildup of grass, leaves,
5. Too much oil in engine.
6. Walking speed too fast.
CAUSE
disconnected.
blade adapter.
position.
equipped) in OFF position.
connector (if equipped).
in STOP position.
housing or cutting blade
dragging in heavy grass.
and trash under mower.
20
CORRECTION
1. Clean/replace air filter.
2. Fill fuel tank.
3. Drain fuel tank and refill tank
with fresh, clean gasoline.
4. Drain fuel tank and refill tank
with fresh, clean gasoline.
5. Connect wire to plug.
6. Replace spark plug.
7. Tighten blade bolt or
replace blade adapter.
8. Depress control bar to
handle.
9. Replace control bar.
10. Turn fuel valve lever
to the ON position.
11. Charge battery.
12. Connect battery to engine.
13. Replace fuse.
14. Place engine control lever
in FAST position.
1. Raise cutting height.
2. Raise cutting height.
3. Clean/replace air filter.
4. Clean underside of mower
housing.
5. Check oil level.
6. Cut at slower walking speed.