Troubleshooting; Specifications - Stanley PI800PS Instruction Manual

800 watt power inverter with usb charging port
Table of Contents

Advertisement

Available languages

Available languages

CARE AND MAINTENANCE
Storage
1. Ideal storage temperature range is 0-40°C (32-104°F).
2. Store and use the PI800P in a cool, dry place with adequate ventilation for all-around air circulation.
3. Avoid locations that are exposed to heating units, radiators, direct sunlight, or excessive humidity or dampness.
Fuse Replacement (in Vehicle Accessory Outlet Plug)
If the inverter is overloaded, and the Power/Fault LED is not lit, the internal 12 amp fuse may be blown.
1. Unscrew the flange of the plug (counterclockwise).
2. Remove the end contact, flange and fuse.
3. Inspect the fuse to see if it is good or blown.
4. Replace with a new 12 amp fuse, if needed.
5. Carefully reassemble the fuse, end contact and flange. Do not overtighten the flange (clockwise).

TROUBLESHOOTING

Common Audio/Visual Problems
Buzzing sound in audio systems
Some inexpensive stereo systems and boom boxes make a buzzing sound when operated from the inverter, because the power
supply in the electronic device does not properly filter the modified sine wave produced by the inverter. The only solution to
this problem is to use a sound system that has a higher quality power supply.
Problem: Television Interference
The inverter is shielded to minimize interference with TV signals. However, in some instances, some interference may still be
visible, especially when the TV signal is weak. Try the following to improve the picture:
1. Move the Inverter as far away as possible from the TV set, the antenna, and the antenna cables. Use a short AC extension
cord, if necessary.
2. Adjust the orientation of the antenna cables, and the TV power cord to minimize interference.
3. Make sure that the antenna feeding the TV provides an adequate (snow-free) signal and that high quality, shielded
antenna cable is used.
Common Power Output Problems
Input voltage below 10.5 volts
Recharge auto battery or check DC power supply.
Equipment being operated draws too much power
• Reduce load to maximum 800 watts if connected via battery clips.
• Reduce load to maximum 120 watts if connected via the 12V dc accessory plug.
• Connect directly to power source using the included Battery Clips when operating above 120 watts.
Inverter in thermal shutdown condition
Allow inverter to cool down. Ensure there is adequate ventilation around the unit and that the load does not exceed the
maximum wattage.
AC output is shorted
Unplug the AC appliance. Disconnect the unit from any 12 volt DC power source. Check the appliance cord.
ACCESSORIES
Recommended accessories for use with this unit may be available from the manufacturer. If you need assistance regarding
accessories, please contact manufacturer at 1-877-571-2391.
WARNING: The use of any accessory not recommended for use with this appliance could be hazardous.
SERVICE INFORMATION
Whether you need technical advice, repair, or genuine factory replacement parts, contact the manufacturer at 1-877-571-2391.
FULL ONE-YEAR HOME USE WARRANTY
The manufacturer warrants this product against defects in materials and workmanship for a period of ONE (1) YEAR from the
date of retail purchase by the original end-user purchaser ("Warranty Period").
If there is a defect and a valid claim is received within the Warranty Period, the defective product can be replaced or repaired
in the following ways: (1) Return the product to the manufacturer for repair or replacement at manufacturer's option. Proof
of purchase may be required by manufacturer. (2) Return the product to the retailer where product was purchased for an
exchange (provided that the store is a participating retailer). Returns to retailer should be made within the time period of the
retailer's return policy for exchanges only (usually 30 to 90 days after the sale). Proof of purchase may be required. Please check
with the retailer for their specific return policy regarding returns that are beyond the time set for exchanges.
PI800PS_ManualENSP_051116.indd 10-11
10
This warranty does not apply to accessories, bulbs, fuses and batteries; defects resulting from normal wear and tear, accidents;
damages sustained during shipping; alterations; unauthorized use or repair; neglect, misuse, abuse; and failure to follow
instructions for care and maintenance for the product.
This warranty gives you, the original retail purchaser, specific legal rights and you may have other rights which vary from state
to state or province to province. This product is not intended for commercial use.
Please complete the Product Registration Card and return within 30 days from purchase of the product to: Baccus Global LLC, One
City Centre, 1 North Federal Highway, Suite 200, Boca Raton, FL 33432. Baccus Global LLC, toll-free number: 1-877-571-2391.

SPECIFICATIONS

Maximum Continuous Power:
800 watts
Input Voltage:
12 volts DC, 79A
Output Voltage:
Approx. 110-125 volts AC RMS, 60 Hz
Wave Form:
Modified Sine Wave (MSW)
Output Connection:
North American Standard Receptacles
USB Output:
5 V DC (2A)
DC plug fuse:
12A/250V
Imported by Baccus Global, One City Centre, 1 North Federal Highway, Suite 200, Boca Raton, FL 33432
www.Baccusglobal.com • 1-877-571-2391
RD051116
11
5/11/2016 11:17:57 AM

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents