Haug Static Control Digital Operating Instruction page 13

Carrying out a measurement
1. Hold the SCD vertically with its two spacer
pins against a grounded surface.
2. Press and hold the start button. The SCD
will calibrate itself and show a value of
"000" on the display.
3. Now approach the surface to be measured
with the SCD, until the spacer pins come to
rest vertically.
4. Release the Start button. The measuring
value will now be saved.
5. Remove the SCD from the surface
measured.
6. Read the measured value on the display.
NOTE:
The measuring value will be displayed for
about 15 s (hold function). The SCD will then
switch off automatically.
7 Measuring
Fig. 8
Fig. 9
13