Watchguard Firebox M200 Configuration Manual page 9

QoS Configuration Guide | WatchGuard M200
7. Now navigate to the 'Advanced' tab. (Figure 6)
Browse down to the 'QoS' section and modify the following values :
a)
i.
Change 'Marking Type' to 'DSCP'
ii. Change 'Marking Method' to 'Assign'
iii. Change 'Value' to '46 (EF)'
iv.
Change 'Prioritize Traffic Based On' to 'Custom Value'
v.
Change 'Value' to '7 (Highest)'
8. Hit 'Save' at the bottom.
9. Select the new Policy 'RingCentral' and change it to Order 1. Once set, hit 'Save Policy Order'.
| Configure Your Firewall
Figure 6
9