Yellow Line 4K/IP Extender 1. INTRODUCTION The 4K HDMI & USB over IP Extender is a solution for audio, video and USB signal extension via Local Area Network (LAN). It can be used as audio, video and KVM extender over IP and applied to point to point, point to multi-point, multi-point to multi-point and video wall broadcast system controlled by USB, RS232, IR and configured the 4K HDMI &...
Yellow Line 4K/IP Extender 3. PACKAGE CONTENTS • Main Unit. HDMI Extender (Transmitter & Receiver) • 2x Power adapter DC 5V • 2x IR TX cables, 4x IR RX cables • 2x Phoenix plugs for RS232 cable termination • 8x screws •...
Page 5
Yellow Line 4K/IP Extender Reset Indicator of Fiber output SFP fiber output CAT5e/6 output HDMI input USB type B input DC 5V input Indicator of Power input 4.2 Receiver Front panel Indicator of SPDIF audio SPDIF Audio output Indicator of Analog audio...
Page 6
Yellow Line 4K/IP Extender Rear panel Reset Indicator of Fiber output SFP fiber input CAT5e/6 input HDMI output USB type A output DC 5V input Indicator of Power input www.movingcolors.eu...
Yellow Line 4K/IP Extender 5. BUTTON DESCRIPTION Button State for Unicast Mode: HDMI Extender: Unicast Digital Button State Transmitter Receiver Button One : Button Two : Button One : Button Two : Short Press Remote/Loopback* Video Mode/ Link on : Link...
Page 8
Currently, we only see Dithering Output with ATI graphic cards. To resolve this issue, Moving Colors Yellow Line provides Anti-dithering for 1 bit, 2 bit, or off. If the source content does not generate dithering output and this feature is turn on. It will create a blocking effect because Video Engine are unable to detect pixel changes.
Page 9
Yellow Line 4K/IP Extender Button State for Multicast Mode: HDMI Extender: Multicast Digital Button State Transmitter Receiver Button One: Button Two: Button One: Button Two: Short Press Remote/Loopback* Video Mode/ Link on: Link Video Mode/ Graphic Mode* Link off: Unlink...
Page 10
Currently, we only see Dithering Output with ATI graphic cards. To resolve this issue, Moving Colors Yellow Line provides Anti-dithering for 1 bit, 2 bit, or off. If the source content does not generate dithering output and this feature is turn on. It will create a blocking effect because Video Engine are unable to detect pixel changes.
Yellow Line 4K/IP Extender 6. INSTALLATION Device Connection • Check the power supply is unplugged. • Set up the group of the transmitter with the correspondent receiver for signal extension and display. • Connect the Transmitter to video source with HDMI cable, and connect Receiver to a monitor or display with HDMI cable.
Page 12
Yellow Line 4K/IP Extender Unicast configuration: Multicast Video Distribution: Figure 2 www.movingcolors.eu...
Page 13
Yellow Line 4K/IP Extender Multicast Matrix Distribution: Figure 3 Billboard & Kiosk, PC to HDMI and USB Interactive Monitor: Figure 4 www.movingcolors.eu...
Page 14
Yellow Line 4K/IP Extender Video wall: Figure 5 www.movingcolors.eu...
Yellow Line 4K/IP Extender 7. IP CONFIGURATION The 4K HDMI & USB Over IP Extender can configure via LAN in the same subnet. 1. Assign a LAN IP address to the computer in the same subnet. The IP address default of the Transmitter and Receiver is B class Networking: 169.254.xxx.xxx.
Page 16
Yellow Line 4K/IP Extender Figure 7 Remark: If the IP address with “Client”, It’s the IP address of the RX If the IP address with “Gateway”, It’s the IP address the TX. 2) The second way. Connect all devices with proper cables, please refer to Figure 9 Figure 8 www.movingcolors.eu...
Page 17
Yellow Line 4K/IP Extender 3) After activation, the device information including the Transmitter and Receiver IP address will be shown in the lower right corner. Remember the Transmitter and Receiver IP address on monitor screen and then plug HDMI video source cable into Transmitter.
Page 18
Yellow Line 4K/IP Extender Figure 10 www.movingcolors.eu...
Yellow Line 4K/IP Extender 8. WEB USER INTERFACE CONFIGURATION The relevant information of the connected extender and setting 8.1.1 [Version Information] Indicating the firmware version and relevant information of the devices Figure 11 8.1.2 [Update Firmware] To update the firmware of the connected extender, please click on the [Select File] to select the firmware and click on [Upload] to upload the firmware and update accordingly.
Page 20
Yellow Line 4K/IP Extender Figure 12 Figure 13 8.1.3 [Utilities] There are some functions Factory Default: Click on to return to the factory default when necessary Reboot: Click on to reboot the extender system Console API Command: Input Linux command for advanced setting...
Page 21
Yellow Line 4K/IP Extender Figure 14 8.1.4 [Statistics] Indicating the extender linking and working status www.movingcolors.eu...
Page 22
Yellow Line 4K/IP Extender Figure 15 www.movingcolors.eu...
Page 23
Yellow Line 4K/IP Extender 8.2 Video Wall To set up the video wall application 8.2.1 [Basic Setup] Figure 16 Bezel and Gap Compensation: Dimension of the screen (inside and outside width and height) OW: outside width OH: outside height...
Page 24
Yellow Line 4K/IP Extender 1) The viewable width must be less than the outside width, and the viewable height must be less than the outside height. 2) If administrator doesn’t need this, just set all values to 0. 3) The unit is 0.1mm and the value MUST be integer.
Page 25
Yellow Line 4K/IP Extender Preferences: Select the video fit in the screen or stretch out and the rotate angle www.movingcolors.eu...
Page 26
Yellow Line 4K/IP Extender Apply To: 1) All: Configure all Transmitter and Receiver in the same Group IP. 2) This (Local): The IP you input into address bar of web browser. 3) Hosts or Clients: select which Transmitter or Receiver you want to configure.
Page 27
Yellow Line 4K/IP Extender Check this box to output each receiver’s specific number to the connected monitor 8.2.2 [Advance Setup] www.movingcolors.eu...
Page 28
Yellow Line 4K/IP Extender www.movingcolors.eu...
Page 29
Yellow Line 4K/IP Extender Before enter “Advanced Setup”, please complete the “Basic Setup” as follows: Step1: In “Basic Setup”, select Vertical and Horizontal Monitor Count. For example Vertical Monitor Count = 3, Horizontal Monitor Count = 5 Sept2: In “Advanced Setup”, choose the target of the video wall to control...
Page 30
Yellow Line 4K/IP Extender If user make incorrect operations, press “Reset” in Reset to Basic Setup function. Setup the video output to “Fit In’ or “Stretch Out” mode in the screen Setup the rotation angle of the video output Set up the number of vertical and horizontal monitor based on the video wall layout.
Page 31
Yellow Line 4K/IP Extender Setup the column position of monitor, number from 0 to the total number of horizontal monitor. Setup the video position shift and video enlarge. Horizontal Shift: Setup the video horizontal shift, Left or Right ...
Page 32
Yellow Line 4K/IP Extender Consol API Command: Input Linux command to do advanced setup. 8.3 Network: Update the network setup of the extender system www.movingcolors.eu...
Page 33
Yellow Line 4K/IP Extender 8.3.1 [IP Setup] Auto IP: use automatically Extender assign IP system for example: 169.254.xxx.xxx. DHCP: use the DHCP of the external device such as the IP sharer to assign IP. www.movingcolors.eu...
Page 34
Yellow Line 4K/IP Extender Static: use the static IP to assign manually. 8.3.2 [Casting Mode] Select the broadcast mode of the extender application Multicast: point to multiple points or multiple point to multiple points broadcast Unicast: point to point broadcast...
Page 35
Yellow Line 4K/IP Extender 8.4 Functions: Setup the video output and USB extension mode for Transmitter Setup the video output and USB extension mode for Receiver www.movingcolors.eu...
Page 36
Yellow Line 4K/IP Extender 8.4.1 [Video over IP]: Setup the video output mode Enable Video over IP: Check to enable video extension over IP Enable Video Wall: Check to enable the video extension for building up video wall ...
Page 37
Yellow Line 4K/IP Extender Customize Scaler Output Mode for Receiver Timeout for Detecting Video Lost www.movingcolors.eu...
Page 38
Yellow Line 4K/IP Extender 8.4.2 [USB over IP]: Setup the USB extension mode Enable USB over IP: Check to enable USB extension mode over IP Operation Mode: Including “auto select mode”, “active on line” and “active per request” modes for option.
Page 39
Yellow Line 4K/IP Extender Broadcast Mode Setting www.movingcolors.eu...
Yellow Line 4K/IP Extender 9. BROADCAST CONFIGURATION SETTING There are some examples to show the setup for unicast, multicast, matrix and video wall. Broadcast setting including unicast and multicast 9.1 Multicast: To enable the USB interactive devices controlled by turns, please check “Auto select USB operation mode per casting mode”8.4 Video wall:...
Page 41
Yellow Line 4K/IP Extender 9.2.2 Advanced Setup Select the monitor you want to control. The one you select will show “This” in green in video wall matrix layout. Take below diagram for example, the monitor we select to control here is the monitor in the upper left corner.
Page 42
Yellow Line 4K/IP Extender Returned to the previous setup of video wall quickly when incorrect operation was input Reset Adjust the horizontal position of the video output, “Left/Right Shift”, the selected monitor to adjust is shown with green outline. Adjust the vertical position of the video output, “Up/Down Shift”, the selected monitor to adjust is shown with green outline.
Page 43
Yellow Line 4K/IP Extender Horizontal Scale Up: To scale up the video output horizontally as the monitor shown with green outline Vertical Scale Up: To scale up the video output vertically as the monitor shown with green outline www.movingcolors.eu...
Page 44
Yellow Line 4K/IP Extender www.movingcolors.eu...