Installation Of Decorative Panel - LG LT-C1260CL Service Manual

7. Installation of Decorative Panel

The decorative panel has its installation
direction.
1. Temporarily fix two decorative panel fixing screws (hexagon M6 screw) on the unit body. (Tighten by amount 10mm in
length.)
The fixing screws (hexagon M6 screw) are included the Indoor unit box.
2. Remove the air inlet grille from the decorative panel. (Remove the hook for the air inlet grille cord.)
3. Hook the decorative panel key hole (
reach the key hole edge.
4. Retighten completely two temporarily fixed screws and other two screws. (Total 4 screws)
5. Connect the louver motor connector and display connector and room temp. thermistor connector.
6. After tightening these screws, install the air inlet grille (including the air filter) and push middle point of inlet grille.
7. Assemble the cover display and the cover.
Air conditioner unit
Piping side
Inlet Grille
Louver motor
Decorative panel
Cover display
Push
Before installing the decorative panel,
always remove the paper template.
) on the screws fixed in step above, and slide the panel so that the screws
Cover
Inlet Grille Inlet Grille
–21–
Decorative panel
fixing screws
(hexagon M6 screws)
Temporarily fitting
at 2 poles
(Tightening about 10mm)
Control box cover
Key holes
Decorative panel
fixing screws
(Hexagon M6 screw)