Yamaha RS7000 Service Manual page 25

7. Connect the 3-wire red/white cable.
• Of the two red/white cables that extend from the I/O
expansion board, first connect the 3-wire cable to the
connector shown in the illustration below (CN7: 3-pin).
Make sure that the direction is correct, and do not try to
force the connection.
8. Connect the other red/white cable (4-wire) in the same way.
• Connect the cable to the connector shown below (CN2: 4-
pin).
9. Secure the cables to the bundle tie.
• Run the 3-wire and 4-wire cables through the bundle tie
(see illustration below), and secure them.
Bundle tie
RS7000
25