Advertisement
3. For display with protruding HDTV tune or deeply
cur ved backs(Fig b), two 9/16" spacers(R) or two
½" spacers(S) should be used. Stack two spacers
and then install them between display and the
bracket. As shown in Fig 1c.
M4 Fig bit
R
3
N
R
N
3
M6 Fig bit
-6-
Fig b
M5 Fig bit
I
R
2
N
S
N
K
2
M8 Fig bit
Fig 1c
WARNING
We are not responsible for any personal injury or product damage due to mishandling,
incorrect mounting, incorrect assembly or incorrect use of this product.
Note:
The supplied wall mounting hardware is not for use on steel stud walls or cold
cinder block walls. If you are uncertain about the nature of your wall, please consult a
qualified contractor. If the hardware you required is not included please contact your
local hardware store or the nearest Circuit City Stores.
Caution :
Caution :
J
with the maximum weights indicated .See apparatus instructions .Use with products
heavier than the maximum weights indicated may result in instability causing possible
injury .
Step 1: Attach bracket to TV
Step 1: Attach bracket to TV
Check your TV manual to confirm the diameter of bolt to be used or choose an
appropriate bolt according to size, height and position of the holes on your TV. See
pages 4-6 of these instructions for examples.
For correct installing, make sure that hook of every bracket must facing down. Use
selected bolt, spacers and washer for installing bracket at the back of display.
Adjust two brackets to equal heights and level. Once aligned, tightly secure the
bolts.
IMPORTANT
IMPORTANT:
equipments and injure of person. Don't use electric drill to fasten any bolts.
L
This Product LCD /Plasma Wall Mount Bracket is intended for use only
Don't force the bolt into the hole, which will cause a damage of
-3-
Advertisement
