Daikin CXTQ36TASBLUA Installation Manual page 19

9.6 DRY MODE 2.0
• Choose DRY mode settings by following Table 13.
If 01 is set, the DRY mode set point will automatically be set
to the measured room temperature at the time that DRY mode
operation is started.
If 02 is set, the DRY mode set point will be the same as the
cooling set temperature at the time of starting DRY mode
operation.
DRY MODE CONFIGURATION
Set point = room temperature
set point = cooling mode set
point
*Factory set
9.7 AIRFLOW SETTING WHEN IN HEATING AND
COOLING THERMO-OFF
• This setting is used to set airflow when the unit is in HEAT-
ING THERMO-OFF. The unit is considered to be HEATING
THERMO-OFF once the heating set point has been satis-
fied and there is not currently a demand for heating.
AIRFLOW WHEN HEATING
THERMO-OFF
LL
User set fan speed
OFF
*Factory set
NOTE:
a. When fan operation is allowed during heating thermo-off,
careful consideration is required before deciding the
installation of duct work, registers and diffusers to avoid cold
drafts.
English
MODE FIRST CODE SECOND
NO. NO. CODE NO.
14 (24) 5
Table 13
MODE FIRST CODE SECOND
NO. NO. CODE NO.
12 (22) 3
Table 14
b. This setting is also valid for the ignition process of gas fur-
nace operation. Therefore, if the user wants to change air-
flow speed during that process, you will be able to use this
setting.
c. During system operation at low ambient temperatures, the
fan may automatically turn off during heating thermo-off re-
gardless of the setting. During this time STANDBY will be
displayed on the controller.
•
This setting is used to set airflow when the unit is in COOL-
ING THERMO-OFF. The unit is considered to be COOL-
ING THERMO-OFF once the cooling set point has been
01*
satisfied and there is not currently a demand for cooling.
02
AIRFLOW WHEN COOLING
THERMO-OFF
LL
User set fan speed
OFF
*Factory set
01
02
03*
MODE FIRST CODE SECOND
NO. NO. CODE NO.
12 (22) 6
Table 15
01
02*
03
19