Update Firmware - General Sleep Zmachine Insight+ DT-200 Service Manual

Update Firmware

Updates to the Zmachine system firmware may be released by General Sleep Corporation (GSC)
from time to time.
To install a firmware update on your Zmachine system:
i) With the Zmachine off, eject the microSD card.
ii) Using the microSD card reader and PC, copy the firmware update file to the microSD
card (do not change the name of this
iii) Properly eject the microSD card reader from the PC.
iv) Return the microSD card containing the firmware update file to the Zmachine
v) Press to boot the Zmachine
vi) Access the Zmachine System Menu.
vii) Select Administrative
viii) Select Update Firmware
ix) If the firmware update was successful, the Zmachine will reboot when the operation
has completed. Otherwise, an error screen will be displayed.
Hint: Following a firmware update, it is always a good idea to access the Zmachine
System Menu →Administrative → About to verify that the correct firmware
update was installed.
30
file).
→ →
System Utilities