Fantech zoo fans installation and operation guide (3 pages)
Summary of Contents for Zoo Fans H25
Page 1
Models: H25 / H30 / H60 Covered by the following United States and International Patents: D631148S, 138172, 001790452-001, 338608 and other patents pending ZOO Fans is a Trade Mark of Zoo Fans Incorporated 1650 38 St, Suite 201W Boulder, CO 80301 (303) 557-1852 zoofans.com...
Page 2
AVERTISSEMENT : Restez vigilent, faites attention à ce que vous faites, et faites preuve de bon sens lors de l’installation de ventilateurs ZOO Fans. N’installez pas de ventilateurs si vous êtes fatigué ou sous l’influence de drogues, d’alcool ou de médicaments.
WARNING: To prevent electrical shock and/or injury disconnect fan from power source before you move or service the fan. Suitable for use with solid-state speed controls. WARNING: To reduce the risk of fire, electric shock, and injury to persons, ZOO Fans must be installed only with controllers supplied by ZOO Fans. Other parts cannot be substituted.
PRE-INSTALLATION The safe installation and operation of equipment supplied by ZOO Fans is the responsibility of the system designer, installer, maintainer, and operator (collectively, the “User”). The need for protective safety accessories to meet company standards, applicable codes, and the requirements of the Occupational Safety and Health Act (“OSHA”) must be determined by the User since safety requirements may vary depending on the location and application of the equipment.
You may also contact your ZOO Fans’ representative or ZOO Fans directly if you require assistance. Remember, the number of ZOO Fans required for the job, as well as where they are hung, will depend on a number of variables, some of which are: •...
The fan intake must be 12” from any obstruction. ZOO Fans are designed to be hung vertically or at an angle. For vertical installations, proceed to STEP 1 below. To install the ZOO Fan at an angle, additional hardware is required. Please contact ZOO Fans or your ZOO Fans’...
Need help?
Do you have a question about the H25 and is the answer not in the manual?
Questions and answers