Table of Contents
Advertisement
7.15
Film Loading Checklist
After understanding all the detailed information on the film loading procedure we have detailed
below an abbreviated check list of the sequence of events. Only use this after you have thoroughly
read and understood the detailed procedures.
Remove remnant film
Clean nip rollers
Release brakes
Remove feed tray
Load top film roll
Thread under top idler bar
Lay on heat shoe with 1" fold back
Place bottom idler bar in "load" position
Load bottom film roll
Check alignment with top roll
Thread under idler bar and lay on the top film web
Push idler bar into "run" position
Replace feed tray
Start machine and push feed plate into nip
Ensure feed plate and film exits the machine cleanly
Stop machine and cut off feed plate
Remove feed tray
Start machine and tension top and bottom film webs
Check for balanced tensions (curl)
Check film alignment
Replace feed tray
Do a test laminate
15
Hide quick links:
Advertisement
Table of Contents
