Related Manuals for Charnwood W020
Summary of Contents for Charnwood W020
- Page 1 FLOORSTANDING ROUTER TABLE MODEL: W020 Charnwood, Cedar Court, Walker Road, Bardon Hill, Leicestershire Tel. 01530 516926 Fax. 01530 516929 email; sales@charnwood.net website; www.charnwood.net...
-
Page 2: General Safety Rules
GENERAL SAFETY RULES WARNING: Do not attempt to operate the machine until you have read thoroughly and understood completely all instructions, rules, etc. contained in this manual. Failure to comply may result in accidents involving fire, electric shock, or serious personal injury. Keep this owner's manual and review frequently for continuous safe operation. - Page 3 GENERAL SAFETY RULES 11. Wear proper apparel. Avoid loose clothing, gloves, ties, rings, bracelets, and jewellery which could get caught in moving parts. Non- slip footwear is recommended. Wear protective hair covering to contain long hair. 12. Always use safety glasses. Also use face or dust mask if operation is dusty.
- Page 4 ADDITIONAL RULES FOR ROUTER TABLE 1. Always hold the workpiece against the fence. 2. Never perform any "free hand" operation. Do not use your hands to support or guide the workpiece. Always use the screw down clamp to secure the workpiece for cutting. 3.
-
Page 5: Specification
Specification Main table surface 683 x 518mm Table tilt Table inserts external diameter 100mm Internal diameter 60mm 29mm Table height 850mm Fence size (each side) 270 x 50mm Dust hood outlet diameter 4” Net weight 54kg Gross weight 56kg Features Can be used with any portable router in the ¾... - Page 6 OVERVIEW OF THE ROUTER TABLE Dust Hood Hold Down Dust Hood Outlet Left Fence Mitre Gauge Handle Right Fence Mitre Gauge Table Tilt Support Lever Switch Mounting Point Floorstand...
- Page 7 Unpacking the Router Table All parts are packed in one carton Unpack the parts carefully and check that everything is present, using the parts list on page 17. If anything is missing contact your dealer immediately. The cast iron table is coated with a layer of grease to prevent rust. This is easily removed with a soft cloth moistened with paraffin.
-
Page 8: Assembling The Floor Stand
Assembling the Floor Stand Important: All nuts and bolts should only be fastened finger tight until assembly is complete. Take two legs and, ensuring that the right hand leg has a set of perforations on its front face (these holes will be used to fix the optional NVR switch if used), join them with the upper front rail. -
Page 9: Installing Your Router
Assembling and Attaching the Fence The fence consists of two precision ground aluminium sections and a dust collector. These are joined by means of a pair of T-slot bolts and nuts. Note that the tee slot on the face plate should be at the top. -
Page 10: Adjusting The Fence
NVR Switch Bolt the NVR switch (if supplied) to the front leg of the table and use this to connect your router to the mains. Adjusting the Fence The faces of the fence can be individually adjusted by loosening the clamping knobs and moving the aluminium sections in or out to suit the diameter of the cutter. - Page 12 CHARNWOOD W020 PARTS LIST Part No. Description Part No. Description Fence Half Positioning Piece Sliding Screw 1/4" x 1" Round Head Screw 1/4" -20tpi x 1-1/2" Hold Down Mount Flat Washer 1/4" Hold Down Motor Clamp Piece L Bay Hexagonal Clamp Piece Knob 5/16"...