Console Password; Firmware Management; Enable Debug Messages; Restore Factory Defaults - Avocent 3100/3200 Installer/User Manual

4. You will be prompted to enter the number of the user you wish to rename. Type the user's
number then press
5. Type a new username and press
6. Enter the password for the user, then re-enter the password to confirm it.
7. Enter (zero) to exit.
0
To remove a user from the AutoView 3100/3200 switch database:
1. From the Console Main menu, type
menu option.
2. Type and press
1
within the database will appear.
3. Type .
D
4. You will be prompted to enter the number of the user you wish to delete. Type the user's
number then press
5. You will be prompted to confirm deletion of the user from the AutoView 3100/3200 switch
database. Type
6. Enter (zero) to exit.
0

Console password

If this is enabled, access to the switch's Console Main menu will require the user to log in.

Firmware management

This menu contains the Flash Download selection. For more information, see Appendix A.

Enable debug messages

This menu option turns on console status messages. Because this can significantly reduce
performance, you should only enable debug messages when instructed to do so by Avocent
Technical Support. When you are finished viewing the messages, press any key to exit this mode.

Restore factory defaults

This menu option will restore all switch options to the default settings.

Reset appliance

This menu option allows you to execute a soft reset of the AutoView 3100/3200 switch.

Exit

This menu selection will return you to the ready prompt. If the Console menu interface password is
enabled, you must exit the Console Main menu so that the next user will be prompted with the
Username and Password login screen.
.
Enter
.
Enter
2
to access the Local User Accounts menu option. A list of users already
Enter
.
Enter
and press to remove the user.
Y Enter
Chapter 6: Terminal Operations
and press to access the Security Configuration
Enter
65