Dell M318WL User Manual page 44

Problem
(continued)
TEMP LED is blinking
amber
The OSD does not appear
on the screen
The remote control is not
operating smoothly or works
only within a limited range
USB Display not displaying
Video file is not supported.
44 Troubleshooting
Possible Solution
If the projector fan fails, the projector will
automatically shut down. Clear the projector
mode by pressing and holding the POWER
button for 10 seconds. Please wait for about
5 minutes and try to power up again. If the
problem persists, contact Dell.
Press the Menu button on the panel for 15
seconds to unlock the OSD.
The battery may be low. Check if the LED
indication from the remote is too dim. If so,
replace with a new CR2032 battery.
Display over USB Should run automatically.
To manually run USB display, go to My
Computer and run "Dell Network Projection
Lite.exe".
NOTE:
You may require
administrator level access to install
the driver. Contact your network
administrator for support.
• Ensure the video file is supported by the
projector's multimedia player. Go to pages
24-24 for Multimedia File Type Support.
• Convert the video file to meet the following
parameters:
Video Setting:
• Code: H.264
• Bit rate: 10Mbps (if it is limited by
program, set it as maximum value
allowed)
• Frame rate: 30 fps (if it is limited
by program, set it as maximum
value allowed)
Audio Setting:
• Code: AAC
• Channel: Stereo
• Sample rate: 48 KHz
• Bit rate: 96 KBps
(continued)