Fcc/ Industry Canada Notice - Primax Electronics M7B301 User Manual

Bluetooth wireless mouse
Table of Contents

Advertisement

8 FCC/ Industry Canada Notice

This equipment has been tested and found to comply with the limits for a
If you have any problems with your Bluetooth mouse, please check
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
the following:
are designed to provide reasonable protection against harmful interference
in a residential installation.
Check the system requirements to make sure that your system
radiate radio frequency energy and, if not installed and used in accordance
is compatible.
with
the
instructions,
Check to see if the batteries in the mouse are installed
communications. However, there is no guarantee that interference will not
correctly. Make sure the polarity of the batteries corresponds
occur in a particular installation. If this equipment does cause harmful
with the polarity signs inside the mouse battery compartments.
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
When the mouse LED is lit red, it indicates battery power low.
the interference by one of the following measures:
Replace them with new batteries immediately.
- Reorient or relocate the receiving antenna.
Once the Bluetooth stack (see "Installing the WIDCOMM
- Increase the separation between the equipment and receiver.
Bluetooth Stack" on page 4) has been installed in your
- Connect the equipment into an outlet on a circuit different from that
computer, you can check the battery status of mouse from
to which the receiver is connected.
Control Panel > Mouse > Bluetooth.
- Consult the dealer or an experienced radio/TV technician for help.
If the mouse fail to work, check the USB mouse function in your
This device complies with Part 15 of the FCC Rules. Operation is subject
system's BIOS. The function should be enabled for the normal
to the following two conditions: (1) This device may not cause harmful
use of mouse.
interference, and (2) this device must accept any interference received,
•f your PC system's BIOS setup has options for the mouse,
including interference that may cause undesired operation.
make sure they are set to default settings. If you are not
familiar with the BIOS, refer to your PC's manual for more
FCC Caution: Any changes or modifications not expressly approved by the
information.
party responsible for compliance could void the user's authority to operate
this equipment.
Only use the mouse on a clean, flat, non-slippery surface in
order to ensure smooth and accurate cursor action. If you use
IC RSS-210:
a mouse-pad, choose a light-colored one, not a dark one, to
Operation is subject to the following two conditions: (1) this device may not
use less battery power.
cause interference, and (2) this device must accept any interference,
For further assistance with any other questions you may have, please
including interference that may cause undesired operation of the device.
contact your dealer for technical support.
IMPORTANT NOTE:
FCC/ IC Radiation Exposure Statement:
This equipment complies with FCC / IC RSS-210 radiation exposure limits
set forth for an uncontrolled environment. End users must follow the
specific operating instructions for satisfying RF exposure compliance.
This transmitter must not be co-located or operating in conjunction with
any other antenna or transmitter.
Bluetooth Mouse Set
This equipment generates, uses and can
may
cause
harmful
interference
to
radio
15

Advertisement

Table of Contents
loading

Table of Contents