Casio fx-9750GII User Manual page 45

k Screen Receiver
Message
A connection could not be
established.
Either the calculator is not
connected or the connected
calculator is not in the Screen
Receiver Mode.
Correct the problem and try
again.
For details, select the following
on the menu bar: Help -
Manual - Manager PLUS, or
refer to the Manager PLUS
user's guide.
A problem occurred during
communication.
Disconnect the USB cable,
check the setup of the
calculator, and try again.
For details, select the following
on the menu bar: Help -
Manual - Manager PLUS, or
refer to the Manager PLUS
user's guide.
Multiple calculators have been
detected.
To start communication, make
sure only one calculator is
connected by USB.
The image could not be sent
from the calculator.
(1) Try pressing a key on the
calculator.
(2) Check to make sure that the
calculator is in the Screen
Receiver Mode.
If the screen is not sent after
you perform the above steps,
disconnect the USB cable and
check the calculator setup.
Next, reconnect and try again.
For details, select the following
on the menu bar: Help -
Manual - Manager PLUS, or
refer to the Manager PLUS
user's guide.
Description
You started a data
communication operation
while the USB cable was not
connected.
Some problem occurred during
data communication.
Multiple calculators are
connected to the computer.
The calculator screen image
cannot be sent for some
reason.
EN-44
Required Action
Check for proper connection of
the calculator to the computer
and confirm that the calculator
is in the Screen Receiver
mode. Then try again.
See "10. Using Screen
Receiver to Display the
Calculator Screen Image on
Your Computer" for details.
Disconnect the USB cable
and check the setup of the
calculation. Then try again.
See "10. Using Screen
Receiver to Display the
Calculator Screen Image on
Your Computer" for details.
Make sure that there is only
one USB connection to a
single calculator before starting
communication.
See "10. Using Screen
Receiver to Display the
Calculator Screen Image on
Your Computer" for details.
Follow the steps that are
shown on the display and try
again.
See "10. Using Screen
Receiver to Display the
Calculator Screen Image on
Your Computer" for details.