Nu-Flame CHESNEYS ALCHEMY EVOLUTION PLUS N2 Use & Maintenance Instructions page 10

When laying the logs ensure that the burner slots
are kept clear.
Position the first log as shown to the left of centre at the
back of the burner against the back bars of the
firebasket.
Position the two side logs, resting on the back log and
leaning against the side bars.
Position the straight left hand centre log resting on a
bark piece at the front and on top of the back log at the
rear. Then position the right hand centre Y log resting on
a bark piece at the front and with the left hand short
branch resting against the last log laid. Please also refer
to the Log notes on page 6 for more info on this final log.
Note. This product contains loose metal fibre which may be sharp. It is advised to where gloves when installing Embaglow.
Tease out the fibres until they form a very loose, very light network of about 400mm long by about 60mm wide. Try to ensure that
clumps of fibres are not formed. A loose network will allow gas to pass through and ensure that maximum glow is obtained. Tear
the 400mm long piece into 4 or 5 sections of between 57mm and 66mm and place these on top of any visible burner slots or
gaps in the fuel effect where there is flame. By raising the height of the fibres above the level of the burner a shimmering glow is
obtained as soon as the fire is lit. Embaglow fibres have a long life but are a consumable item and will eventually deteriorate.
ALCHEMY 22 UNIVERSAL FUEL EFFECT LAYOUTS
Before commencing please also refer to the Tips section on page 6
Replacements can be obtained from your stockist
There are many shapes and sizes of coal but for the
purposes of the layout we will describe them as small
medium and large. This will be clearer when the coals
are laid out and the instructions below are followed.
When laying the coals ensure that the burner slots
are kept clear.
The bottom layer of coals is positioned on top of the
black bark pieces.
• For the front row use small coals, laid against the
front bars and this will keep the burner slots clear. Do
not cover the pilot cut-out.
• Find suitably shaped medium or large coals to lay on
the black burner insulation pad and place in such a
way as to not cover the slots.
• For the reminder of the bottom layer use large or
medium coals for the best aesthetic effect.
Place the remaining coals on top of the bottom coal layer
in a similar way to the photograph above
Embaglow material
Page 10 of 12