VTech BM2600 User Manual page 39

Appendix
Troubleshooting (continued)
• You may have set the senstvty level to a very low level. If you do
so, the baby unt wll not detect sounds that s too soft or lght. You
may need to adjust the senstvty level to a hgher level (pages 24
and 25).
• Large obstructons may mpact the recepton. Try to relocate the
baby unt, away from large obstructons such as walls and doors.
• Remove and nstall the battery agan. Turn on the baby unt and the
parent unt. Allow up to one mnute for the parent unt and the baby
unt to synchronze.
• Other electronc products may cause nterference wth your vdeo
and audo montor. Try nstallng your vdeo and audo montor as
far away from these electronc devces as possble: wreless routers,
rados, cellular telephones, ntercoms, room montors, televsons,
personal computers, ktchen applances and cordless telephones.
The light flashes on the parent unit.
• Charge the battery n the parent unt for up to 12 hours.
• Completely remove and nstall the battery agan and use t untl fully
depleted, then recharge the battery n the parent unt for up to
12 hours.
• If the above measures do not correct the problem, replace the
battery.
The battery does not charge in the parent unit or the
parent unit battery does not accept charge.
• Make sure the battery s nstalled n the parent unt battery compartment
correctly. The
• Completely remove and nstall the battery agan, then charge for up to
12 hours.
lght on the parent unt s not on, refer to The
• If
parent unit is off below.
• If the battery s completely depleted, t may take up to 30 mnutes to
charge the parent unt before t can be used for a very short tme
(page 9).
Purchase a new battery. Refer to Parent unit battery installation
•
(page 5) and Parent unit battery charging (page 9).
lght on the parent unt should be on.
32
light on the