Vehicle Positioning - Chevrolet Camaro 2018 Manual

44 Navigation
Plan Route
Touch My Destination to display a
special version of the Manoeuvre
View. The Destination Address is
displayed in the Street Name and
the total distance to the destination
is displayed in the Distance to
Manoeuvre View. Touch Done to
return to the Manoeuvre View.
Cancel Route
If a route is in progress using either
the vehicle navigation system or the
OnStar Turn-by-Turn route, and a
new route is requested, the current
route in progress will be cancelled.
An OnStar Advisor can cancel the
vehicle navigation system route.
Route guidance can be resumed by
touching the Resume to option in
the Map Menu.
Global Positioning
System (GPS)
The position of the vehicle is
determined by using satellite
signals, various vehicle signals, and
map data.
At times, other interference such as
the satellite condition, road
configuration, condition of the
vehicle, and/or other circumstances
can affect the navigation system's
ability to determine the accurate
position of the vehicle.
The GPS shows the current position
of the vehicle using signals sent by
GPS satellites. When the vehicle is
not receiving signals from the
satellites, a symbol appears on the
map screen. See Navigation
Symbols 0 28.
This system might not be available
or interference can occur if any of
the following are true:
Signals are obstructed by tall
buildings, trees, large trucks,
or a tunnel.
Satellites are being repaired or
improved.
For more information if the GPS is
not functioning properly, see
Problems with Route Guidance 0 45
and If the System Needs Service
0 45.

Vehicle Positioning

At times, the position of the vehicle
on the map could be inaccurate due
to one or more of the following
reasons:
The road system has changed.
The vehicle is driving on slippery
road surfaces such as sand,
gravel, or snow.
The vehicle is travelling on
winding roads or long straight
roads.
The vehicle is approaching a tall
building or a large vehicle.
The surface streets run parallel
to a freeway.
The vehicle has been transferred
by a vehicle carrier or a ferry.
The current position calibration
is set incorrectly.
The vehicle is travelling at high
speed.
The vehicle changes directions
more than once, or the vehicle is
turning on a turn table in a
car park.