Chevrolet Camaro 2018 Manual page 13

Slide a finger to the right or left
to scroll through each page of
favourites.
l
Tone Settings : Drag
display the favourites. Touch and
hold a preset to store the current
tone settings as a favourite. Touch a
saved favourite to recall a favourite
tone setting.
The number of favourites displayed
is automatically adjusted by default,
but can be manually adjusted in the
Settings menu under Radio and
then Number of Favourites Shown.
Radio Data System (RDS)
The audio system has an RDS.
RDS features are available for use
only on FM and DAB stations that
broadcast RDS information. With
RDS, the radio can:
Seek to stations broadcasting
the selected type of
programming
Receive announcements
concerning local and national
emergencies
Display messages from radio
stations
This system relies on receiving
specific information from these
up to
stations and only works when the
information is available. In rare
cases, a radio station may
broadcast incorrect information that
causes the radio features to work
improperly. If this happens, contact
the radio station.
The RDS system is always on.
When information is broadcast from
the current FM station, the station
name or call letters show on the
audio display. RDS may provide a
programme type (PTY) for current
programming and the name of the
programme being broadcast.
When RDS signal information has
been detected, the metadata fields
will be updated on the infotainment
display to show the RDS data. The
radio text will be updated any time
new information is received.
The RDS fields on the display will
show in the following order:
Frequency and/or RDS-PSN.
Radio
RDS text line one is the
information provided by the
broadcast.
RDS text line two and three is
RDS text. Line three is used only
if necessary, to wrap over from
the text on line two.
If the RDS text information
overflows from line two and three,
the previous information given on
line two and three will clear. The
overflow of information will finish
starting from the previously used
line two and then if necessary, line
three.
If an RDS text update occurs during
the paging, the display fields are
cleared and the new information is
displayed, beginning on line two.
Once the entire broadcast text is
finished paging, the amount of text
that can fit in lines two and three will
be displayed and an ellipsis will
indicate further text exists.
13