Table of Contents
Advertisement
CONNECTING COMPOSITE VIDEO
You can display composite video (NTSC, PAL or SECAM) on the DP5500.
Figure 2-14 Video 1 & 2 ports
Use the supplied AV cable (see page 1-2) to connect an NTSC, PAL, or
SECAM source to your projector.
1 Find the RCA connector on your video source marked Video Out
(or something similar). This connector is usually yellow. Insert one of the
AV cable's yellow connectors into the Video Out jack on the video source.
2 Insert the other yellow connector into the projector's VIDEO 1 port.
CONNECTING AN S-VIDEO SOURCE
To connect an S-Video source, use the supplied S-Video cable (see page 1-2)
instead of an RCA cable connection. The S-Video cable has identical, round,
4-pin mini-DIN connectors on both ends.
Figure 2-15 The S-VHS port
To connect an S-Video source:
1 Insert one end of the S-Video cable into the mini-DIN Video Out port on
the video source.
2 Insert the other end of the S-Video cable into the projector's S-VIDEO
port.
Setting Up the Desktop Projector 5500
2-11
Advertisement
Table of Contents
