Advertisement
A
Clamp Pad Adapter:
The adapter accepts the large pad of all Kreg face clamps and
snaps into the back of the jig, turning clamp and jig into one
assembly for fast jig positioning.
B
Drill Guide:
This two-hole drill guide keeps your drilling stroke straight and
true. The hardened steel guides are guaranteed for the life of
the tool.
C
Easy-Press
Adjust these two sliders with a press of your thumb to set the jig
for different workpiece thicknesses.
D
Chip Release Holes:
Two holes at the base of each drill guide allow wood chips to
escape for fast drilling, reduced heat build-up, and longer drill
bit life.
E
Mounting Hole:
For tight locations where you can't use a clamp, secure the jig to
the workpiece by driving a wood screw through this hole.
F
Clamp Adapter Holes:
Two key-hole slots provide tool-less attachment for the clamp pad
adapter.
G
Stop Collar | Hex Wrench:
Set drilling depth by positioning the stop collar on the drill-bit
shank.
H
⅜" (9.5mm) Stepped Drill Bit | #2 Square Driver:
The special drill bit, made of hardened high-speed steel, drills the
pocket hole and pilot hole in one operation. The 6" [152mm]-long
driver bit provides clearance to keep your drill/driver aligned
with the pocket screw.
Positioning Sliders:
™
Parts
www.kregtool.com
Advertisement
