D-Link DIR-130 Troubleshooting Manual page 4

Step 6. Disable any Internet security software running on the computer. Software firewalls like Zone Alarm, Black Ice, Sygate,
Norton Personal Firewall, etc... As these might block access to the router's configuration pages. Check the help files included
with your firewall software for more information on disabling or configuring it.
Step 7. If you still cannot log into the router:
- Cycle the power on the router. Switch the power off. Wait 20 to 30 seconds. Switch the power on and wait for the lights to
stabilize.
- Restart the computer.
- Go to: Start > Run > type "cmd" (without quotes) > OK . In the DOS window type: ping 192.168.0.1 and press Enter . You
should see "Reply from..." messages.
If your ping was successful, attempt again to access the router's configuration page.
Try these options in the address window.
192.168.0.1
http://192.168.0.1
http://192.168.0.1:88
If you cannot ping the router check your IP settings. In the DOS window type "ipconfig" (without quotes) and press Enter. The IP
address on your network adapter should be in the 192.168.0.xrange. Type "arp -d" (without quotes) and press Enter. Repeat
this command several times until you get "The specified entry was not found" message. Try to access the router again.
Reset the router. Try using another computer.
D-Link Technical Support – Cannot access the routers web interface. Page 4 of 4