D-Link DIR-130 Troubleshooting Manual page 2

Can not access the router on 192.168.0.1

Step 3. Check your IP address. Your computer must have an IP address in the same range of the device you are attempting to

configure. Most DI-series devices use the 192.168.0.x range. If you are attempting to configure a D-Link router, then make sure

you take note of your computer's Default Gateway IP address. The Default Gateway should be the IP address of the D-Link

router. By default, it should be 192.168.0.1.

Set you computer with a static IP address:

Go to

Control Panel

Network Connections

Local Area Connection

Properties

Select

Internet protocol TCP/IP

and click on

Properties

Select the "

Use the following IP address / Use the following DNS

" options. Specify the TCP/IP settings you want to use:

IP address: 192.168.0.5

Subnet mask: 255.255.255.0

Default Gateway: 192.168.0.1

Preferred/Alternate DNS: 202.129.64.198 / 4.2.2.3 (or whichever your provider is using).

Click on

and then

again.

D-Link Technical

Support – Cannot access the routers web interface.

Page 2 of 4