ProForm TREADMILL 831.24623.0 User Manual page 8

5. Set the Console (43) face down on a soft surface
to avoid scratching the Console. Next, set one of
the Handrails (71) on the Console as shown.
Attach the Handrail with three 3/4" Screws (2).
Make sure that the console wire is not
pinched. Start all three Screws before tight-
ening any of them. Do not overtighten the
Screws.
Then, attach the other Handrail (not shown) to
the other side of the Console (43) as described
above.
With the help of a second person, raise the
Uprights (not shown) to the vertical position.
6. Remove the plastic tie holding the Wire Harness
(42) to the right Upright (69). Insert the colored
tie on the Wire Harness up through the large
holes in the right Handrail (71) as shown. Pull
the Wire Harness up through the holes.
Next, set the Handrails (71) with the Console
(43) onto the tops of the Uprights (69). Make
sure that the Wire Harness (42) and the con-
sole wire are not pinched. Untie and discard
the colored wire.
Then, connect the Wire Harness (42) to the con-
sole wire. Make sure to connect the connec-
tors properly (see the inset drawing). The
connectors should slide together easily and
snap into place. If the connectors do not slide
together easily and snap into place, turn one
connector and try again. IF THE CONNECTORS
ARE NOT CONNECTED PROPERLY, THE
CONSOLE MAY BE DAMAGED WHEN THE
POWER IS TURNED ON. Insert the connectors
and excess wire into the Console (43).
7. Tighten the four Handrail Bolts (37) with the four
1/4" Star Washers (95) into the Uprights (69) and
the Handrails (71). Start all four Bolts before
tightening any of them.
5
71
Console Wire
43
6
43
Colored Tie
71
Console
Wire
42
69
7
71
37
95
95
37
69
8
2
2
2
Console
Wire
42
71
37
95
69
37
95