BAP Precision S SERIES User Manual page 79

RF exposure warning
The equipment complies with FCC RF exposure limits set forth for an uncontrolled
environment.
The antenna(s) used for this transmitter must not be co-located or operating
in conjunction with any other antenna or transmitter.
RF exposure information (SAR)
This GPS Controller meets the government's requirements for exposure to radio
waves.
This GPS Controller is designed and manufactured not to exceed the emission
limits for exposure to radio frequency (RF) energy set by the Federal
Communications Commission of the U.S. Government.
The exposure standard for wireless GPS Controllers employs a unit of measurement
known as the Specific Absorption Rate, or SAR. The SAR limit set by the FCC
is 2.0 W/kg.
Tests for SAR are conducted using standard operating positions accepted by the
FCC with the GPS Controller transmitting at its highest certified power level in
all tested frequency bands. Although the SAR is determined at the highest certified
power level, the actual SAR level of the GPS Controller while operating can be
well below the maximum value. This is because the GPS Controller is designed
to operate at multiple power levels so as to use only the poser required to reach
the network. In general, the closer you are to a wireless base station antenna,
the lower the power output.
The highest SAR value for US model GPS Controllers as reported to the FCC
when tested for use at the body, as described in this user guide, is 1.280 W/kg.