Table of Contents
Advertisement
User's Guide
Step 2
Select your controller and right click. Select Open WEB item to launch the web
management interface through the secure https connection:
Step 3
Enter the Access Controller administrator login settings to access the web
management interface.
The default administrator log on settings for all controller interfaces are:
User name: admin
Password: admin01
Step 4
After successful administrator log on you will see the controller web interface. The
controller system statistics page is displayed by default:
If you cannot connect to the device via your web browser because of TCP/IP mis-
configuration, you can reset the product to the factory default. Press the reset
button for more than 5 seconds.
Now you are enabled to perform the initial controller configuration. Follow the next section for step-by-
step setup instruction to configure the device according to your needs.
Gemtek Systems
Installation
Page 18
Advertisement
Table of Contents
Need help?
Do you have a question about the P-560 and is the answer not in the manual?
Questions and answers