How To Use The Manual Mode; How To Turn On The Power - ProForm PFTL61930 User Manual

HOW TO TURN ON THE POWER

Plug in the power cord (see page 10).
1
Locate the reset/off
2
circuit breaker on the
treadmill near the
power cord. Make
sure that the circuit
breaker is in the reset
position.
Stand on the foot rails of the treadmill. Find the clip
3
attached to the key (see the drawing on page 11)
and slide the clip onto the waistband of your
clothes. Next, route the cord attached to the clip
under the handgrip pulse sensor, and insert the
key into the console. After a moment, the displays
and various indicators will light. Test the clip by
carefully taking a few steps backward until the
key is pulled from the console. If the key is not
pulled from the console, adjust the position of
the clip.

HOW TO USE THE MANUAL MODE

Insert the key fully into the console.
1
See HOW TO TURN ON THE POWER above.
Select the manual mode.
2
When the key is in-
serted, the manual
mode will be selected
and the indicator on the
Manual Control button
will light. If you have se-
lected a program, press the Manual Control button
to reselect the manual mode.
Press the Start button or the Speed + button to
3
start the walking belt.
A moment after the button is pressed, the walking
belt will begin to move at 1 mph. Hold the handrails
and begin walking. As you exercise, change the
Reset
Position
12
speed of the walking belt
as desired by pressing
the Speed + and – but-
tons. Each time a button
is pressed, the speed
setting will change by
0.1 mph; if a button is held down, the speed set-
ting will change in increments of 0.5 mph. To
change the speed setting quickly, press the Quick
Speed buttons.
To stop the walking belt, press the Stop button.
The Pace/Time display will begin to flash. To
restart the walking belt, press the Start button or
the Speed + button.
Note: The first time the treadmill is used, observe
the alignment of the walking belt, and align the
walking belt if necessary (see page 28).
Change the incline of the treadmill as desired.
4
To change the incline of
the treadmill, press the
Incline buttons. Each time
a button is pressed, the
incline will change by
0.5%.
Follow your progress with the matrix and the
5
displays.
The matrix—When the
manual mode or the
iFIT.com mode is se-
lected, the matrix will
display a 1/4-mile track.
As you exercise, the in-
dicators around the track
will light in succession until the entire track is lit.
The track will then darken and the indicators will
again begin to light in succession.
Incline/Heart Rate
display—This display
shows the incline level of
the treadmill. This display
will also show your heart
rate when you use the
handgrip pulse sensor or the optional chest pulse
sensor.