ProForm PFTL31304.0 User Manual page 7

2. Identify the Right Upright (10), which has the Upright Wire
Harness (17) inside of it. Orient the Right Upright as
shown. Cut the band securing the lower end of the Upright
Wire Harness.
Have a second person hold the Right Upright (10) near the
Base (82). Connect the Upright Wire Harness (17) to the
wire harness extending from the Base. Make sure to con-
nect the connectors properly (see drawing 2a). The
connectors should slide together easily and snap into
place. IF THE CONNECTORS ARE NOT CONNECTED
PROPERLY, THE CONSOLE MAY BE DAMAGED
WHEN THE POWER IS TURNED ON. See drawing 2b.
Carefully wrap the wires around the connectors. Insert the
connectors and the excess Wire Harness into the Base as
shown, and then hold the Right Upright against the Base.
Be careful not to pinch the wires.
Insert two 2 3/4" Bolts (47), with two Washers (29) and two
Star Washers (81), into the Base (82), and loosely thread
the Bolts into the lower end of the Right Upright (10).
Attach a Wheel (95) to the Base (82) with a Wheel Bolt (86).
Do not overtighten the Bolt; the Wheel must be able
to turn freely.
With the help of a second person, tip the treadmill onto its
right side. Attach the Left Upright (9) and the other Wheel
(not shown) as described above. Note: There are no wires
in the Left Upright.
3. With the help of a second person, tip the treadmill onto
the Base (not shown), with the Left and Right Uprights
(9, 10) in a vertical position.
Open part bag B. Hold the Crossbar (88) between the
handrails on the Left and Right Uprights (9, 10). Make
sure that the square hole in the Crossbar is on top as
shown. Attach the Crossbar with two Crossbar Bolts (56).
Firmly tighten the Crossbar Bolts.
2
82
81
29
47
29
47
2a
17
3
9
56
7
10
17
86
81
2b
88
10
Square
Hole
9
95
56