Setting Preset Stations - Chevrolet 2008 T Series Owner's Manual

Setting Preset Stations

Up to 18 stations (six FM1, six FM2, and six AM), can
be programed on the six numbered pushbuttons,
by performing the following steps:
1. Press FM/AM to select FM1, FM2, or AM.
2. Tune in the desired station by pressing
y z
the arrows.
3. Press and hold one of the six numbered
pushbuttons. When that numbered pushbutton
is pressed, the station that was set, returns for
that pushbutton.
4. Repeat the steps for each pushbutton.
The stored preset stations are deleted if power to the
radio is lost, or if the battery is disconnected.
Setting the Tone (Bass/Treble)
AUDIO: Press and release until BASS (BA:0) or
TREBLE (TR:0) displays. The display shows the bass or
treble level. Each time the AUDIO button is pressed,
the audio mode indicator changes. Once the desired
tone displays, press either
decrease the setting.
If a station is weak or has static, decrease the treble.
If AUDIO is not pressed, after 10 seconds audio
mode times out and returns to NORMAL MODE.
Adjusting the Speakers (Fade/Balance)
AUDIO: To adjust the fade between the front and
the rear speakers, press and release until FADER (FA:0)
y z
displays. Press either
sound toward the front or the rear speakers.
To adjust the balance between the right and the left
speakers, press and release the AUDIO button until
BALANCE (BL:0) displays. Press either
move the sound toward the right or the left speakers.
The FADER adjust becomes disabled when there are
only two speakers available in the vehicle.
y z
arrow to increase or
arrow to move the
y z
arrow to
3-41