Table of Contents
Advertisement
If you have edited a mix and have not stored it to a memory location,
this mix will not be recalled when the SysEx data is loaded into the
A-16R later.
Loading . via MIDI
The A-16R can load Presets saved as either single Preset files or as All
Preset files that include the complete set of sixteen memory locations.
As when recalling a Preset from the internal memory, you must first
enter Recall Mode to load a Preset. (Recall Mode on the A-16R is
entered by pressing the R
Remember that you need to have MIDI cables properly connected
between the A-16R and your MIDI recording devices to load presets.
Connect MIDI Out from your storage device to MIDI In on the A-16R.
Loading One Preset via MIDI
To load a single Preset that was saved to a MIDI recording device, the
A-16R must first be placed into Recall Mode. Remember that MIDI
reception is activated only when the front panel R
is in the L
position.
OCAL
While waiting for valid MIDI SysEx information, the A-16R will
remain in MIDI Recall until a valid A-16R MIDI message is received,
or until you press another front panel button to exit MIDI mode. SysEx
information for other manufacturer's devices will pass through the
A-16R and be ignored.
To load one Preset:
Set the A-16R R
1.
tion.
2. Press the R
flashes.
3.
Press the S
reception. The LED in the S
4. Send the single Preset SysEx data from your MIDI
storage device.
5.
The Preset is loaded into internal memory and is ready
to be used as is and/or edited.
6. Save your Preset to an internal memory location.
When a SysEx transfer is complete, the system will display a status
message to confirm that the data was received properly. Two messages
are possible:
• Valid Data Received - all yellow Mute LEDs will flash
• Invalid Data or MIDI Error - all red Channel LEDs will
button.)
ECALL
/L
EMOTE
OCAL
button. The R
ECALL
button to arm the A-16R for MIDI
OLO
EMOTE
switch to the L
OCAL
button LED
ECALL
button will blink.
OLO
/L
switch
OCAL
posi-
59
Advertisement
Table of Contents
