Table of Contents
Advertisement
turn the knob counterclockwise past the center. To change the high-
frequency content, follow the same procedure; turn the T
right to add highs, left to diminish them.
The Bass and Treble EQs in the Personal Mixer are both shelving type.
There is +/-12dB of cut or boost available for each.
Bass EQ - 160Hz shelving
Treble EQ - 9kHz shelving
+12dB
Master Volume
The overall system volume is controlled by the M
control, not to be confused with the Channel Volume control. This is
a digitally-controlled analog volume control. Turn it counterclockwise
for a full off setting. As a general suggestion, start with the Master
Volume knob at a low setting, about 9 or 10 o'clock to start. Raise the
volume slowly from that point to a comfortable level.
Note: Always use caution when adjusting any audio
system component to avoid potential hearing
damage.
Button Behaviors
There are various combinations of lighted and unlighted buttons on the
A-16R Personal Mixer. Here is an overview:
• Channel buttons have two LEDs, an upper and lower.
The upper button is red and indicates that the Channel
is selected. The lower button is yellow; it indicates that
the Channel is muted. Channel buttons will light solid
or flash.
• The R
ECALL
the R
ECALL
now select a Preset by touching any numbered button.
• There is one LED in the G
G
ROUP
indicates that you can now build or edit a Group.
160Hz
-12dB
button has one red LED. It flashes when
button is pressed, indicating that you can
button is pressed, the LED flashes. This
9kHz
ASTER
button. When the
ROUP
knob
REBLE
+12dB
-12dB
V
OLUME
27
Advertisement
Table of Contents
